Acano Solution Przewodnik Instalacji Pobierz pdf (Strona 31)

Dial Plan Configuration – SIP Endpoints

Acano solution: Deployment Guide R1.2 76-1006-06-K

Page 31

5.2 SIP Endpoints Dialing a Call on the Acano Solution

As a starting point, consider using only SIP video endpoints and the configuration on the VCS

and Acano solution to direct and host calls for these endpoints.

Figure 6: Example of SIP video endpoints calling into an Acano Server hosted calls

5.2.1 SIP call control configuration

This example assumes the SIP Call Control is a Cisco VCS but similar steps are required on

other Call Control devices.

Set up a zone to route calls to the Acano solution by logging into the VCS as an administrator

and following the steps below.

1. Go to VCS Configuration > Zones > New.

2. Create the zone with the following:

 H.323 Mode = Off.

 SIP Mode = On

 SIP Port = 5060 (5061 if using TLS)

 SIP Transport = TCP or TLS, as appropriate

 SIP Accept Proxied Registrations = Allow

 Authentication Policy = Treat as authenticated

 SIP Authentication Trust Mode = Off

 Peer 1 Address = the IP address of the Call Bridge

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 93 94

Brak uwag

Acano Solution Przewodnik Instalacji Strona 31